Differences
This shows you the differences between two versions of the page.
| Next revision | Previous revision | ||
| projects:gamecube [2023/08/06 21:14] – created davenport | projects:gamecube [2025/02/10 23:31] (current) – davenport | ||
|---|---|---|---|
| Line 1: | Line 1: | ||
| - | STATUS: | + | STATUS: |
| ====GameCube Mods and Repair==== | ====GameCube Mods and Repair==== | ||
| //modding and repair of GameCube systems.// | //modding and repair of GameCube systems.// | ||
| - | {{ projects:crafty-penguin.png?200}} | + | {{ projects:gcbottom2.jpg? |
| ===Items Needed=== | ===Items Needed=== | ||
| Line 16: | Line 16: | ||
| ===NOTES=== | ===NOTES=== | ||
| - | A laser eye from the 001 GC needs resistance set between | + | Laser Eye Assembly always needs the potentiometer tweaked. Measure the resistance across the left leg and bottom right leg |
| + | |||
| + | **LOWER Ohms = MORE LASER** | ||
| + | |||
| + | Start with higher resistance and work your way down slowly. | ||
| + | |||
| + | 200 to 500 Ohms is the average resistance. **DO NOT GO UNDER 175!!!** | ||
| + | |||
| + | * 001 GC laser needs resistance set between | ||
| + | * 101 GC laser needs resistance set between 150 - 250 | ||
| + | |||
| + | Examples: Jon's old GC started at 216 and read at 196; Marc's newer GC started at 276 and read at 199 | ||
| - | A laser eye from 101 GC needs resistance set between x and y | ||
| ===More Information=== | ===More Information=== | ||
| A youtube or [[google> | A youtube or [[google> | ||